JVC GR-DF428 Instruction Manual

Dubbing To A Video Unit Equipped With A DV Connector Digital Dubbing

Dubbing To A Video Unit Equipped With A DV Connector Digital Dubbing

EN
 41
EDITING
MasterPage: Start_Right
ADV
A
N
C
ED
 F
EA
T
UR
ES
It is also possible to copy recorded scenes from 
the camcorder onto another video unit equipped 
with a DV connector. Since a digital signal is 
sent, there is little if any image or sound 
deterioration. 
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit 
equipped with a DV input connector using a DV 
cable as shown in the illustration.
3
Start playback on the camcorder. (
੬ pg. 22)
4
At the point you want to start dubbing, start 
recording on the video unit. (Refer to the video 
unit’s instruction manual.)
5
To stop dubbing, stop recording on the video 
unit, then stop playback on this camcorder.
NOTES:
● It is recommended to use the AC Adapter as 
the power supply instead of the battery pack. 
(
੬ pg. 15)
● If a blank portion or disturbed image is played 
back on the player during dubbing, the dubbing 
may stop so that an unusual image is not dubbed.
● Even though the DV cable is connected correctly, 
sometimes the image may not appear in step 
4. If 
this occurs, turn off the power and make 
connections again.
● If “Playback Zoom” (੬ pg. 26) or “Playback 
Special Effects” (
੬ pg. 26) is attempted or 
SNAPSHOT is pressed during playback, only the 
original playback image recorded on the tape is 
output from the DV OUT connector.
● When using a DV cable, be sure to use the 
optional JVC VC-VDV204U DV cable. 
Dubbing To A Video Unit Equipped 
With A DV Connector (Digital 
Dubbing) 
Core filter
To DV OUT
DV cable (optional)
To DV IN
Video unit equipped with DV connector
GR-DF428AH_06Advanced.fm  Page 41  Tuesday, March 22, 2005  2:01 PM